psx80104/shredder

Regarding the shredding chamber design of lined bolted wear plates, and 80mmthickness of general housing fabrication and abrasive resistant wear plates.Liner wear plates are only mounted on the side walls within the shredding chamberOur roof bars are of cast manganese material, held in place with external tie bars whichin addition to making replacement a simple task, also removes the risk of those barsfalling into the shredder.
Bottom, middle and cover box
It consists of the base of the main machine, the middle part, cover and rotor groupshammer, pin protector, pin, cylinder, liners, ejection gate. Under the constant thehammering, which will break scrap up after the material entering the shredder.
The fabrication of the main machine is welded, and protected by a high manganese steelliner. Large grids are mounted on the bottom, with an ejection gate mounted on the toppart of the mill. The scrap should be reduced to allow exit from the mill which isdetermined by the grids hole size.
Any unshreddable material will be ejected out ofthe mill through the ejection door.